Hi, I'm new to troopers as its recently purchased and I've just joined this group.

Do I have to tow my 3.0l (4jx1) to the only garage in 15 miles with who has a tech 2 reader?
It’s not fuelling, won’t start. Has had fuel line work then started being hard to start and now is dead after a short while and won’t start plus not pulling fuel through the filter.
Anyone have some experience of this?
Has anyone used the one on ebay to code readers, any good?

 

Facebook trooper group was wicked.
I ran some 8mm plastic pipe into a clean jerry can of diesel and bypassed the fuel filter by forcing it down the rubber fuel line to the engine,
it started eventually and it idled well.
So gotta be the lines up on the fuel tank or less likely the hand primer diagram.
Thought I'd share.