Body Lift Help for a New Guy
#1
Body Lift Help for a New Guy
Hi -
I just helped my buddy install a Roger Brown body lift (1.5") on his 99 Rodeo. When installed, we removed the factory spacers and replaced them with the the Polyurethane pucks. Was this correct? Or were we supposed to put the PU pucks ON TOP of the factory spacers? (On ym 3rd gen 4runner, replacing them is the proper way).
Also, I can see how to adjust the front bumper to rid the gap, but what about the rear bumper?
The way we did it, it turned out looking good, but wondering if we could have ended up with a little more lift? Everything went together nicely. More than anything, I want to make sure we did it right!
Thanks for the help in advance.
I just helped my buddy install a Roger Brown body lift (1.5") on his 99 Rodeo. When installed, we removed the factory spacers and replaced them with the the Polyurethane pucks. Was this correct? Or were we supposed to put the PU pucks ON TOP of the factory spacers? (On ym 3rd gen 4runner, replacing them is the proper way).
Also, I can see how to adjust the front bumper to rid the gap, but what about the rear bumper?
The way we did it, it turned out looking good, but wondering if we could have ended up with a little more lift? Everything went together nicely. More than anything, I want to make sure we did it right!
Thanks for the help in advance.
Thread
Thread Starter
Forum
Replies
Last Post