i got almosr 3 inches when i did mine but the upper ball joints are at a tight angle there is a web site that sells spacers to corect this as for the bump stobs i just too the bottom ones off as i dont do nothing ruff but you can get the little round ones like on top a frame and they will bolt right inn the bottom

 

tight angle as in they will break?

 

ball joints are in a tight angle as in they might break?.....and how can i raise the *** end?

 

havint had one break but mine are new but there is a posibility have they move far enough as for the back end mine i put new akle purch-is and moved my rear axle under the springs but a good set of add a leafs will give you about an 2 inch lift as the back was normally higher than the front from the factory it would make you level

 

How do you remove the torsion bar without the removal tool??? Can it be done if so whats the best way

 

you can use a regular c clamp to do it but if it slips off then that would suck. most auto places will rent you one for a small deposit

 

I W Marks Opens Second Location | I W Marks Houston's largest independent jeweler has opened a second store at 2623 Town Center Blvd. in Sugar Land. The store will showcase such premiere jewelry lines as Lazare Diamonds Jeff Cooper Platinum Artcarved and Diana wedding bands bvlgari bvlgari-bvlgari replica watches and Charriol. There will be an extensive selection of fine Swiss watches from Rolex replica watches Baume & Mercier Raymond Weil replica cheap technomarine watches Tag Heuer porsche design watches u-boat gold replica watches Concord and Omega plus fine writing instruments and Jay Strongwater multi-jeweled and enameled picture frames. For information call (713) 668-5000 or visit www.iwmarks.com.